Sample Mode | Real-Time Sample Rate |
Real-Time Sample Rate | Analogue channel: 1 GSa/s (single-channel), 500 MSa/s (dual-channel), 250 MSa/s (three/four-channel) Digital channel: 1 GSa/s (8-channel), 500 MSa/s (16-channel) |
Peak Detect | Analogue channel: 4 ns Digital channel: 4 ns |
Averaging | After all the channels finish N samples at the same time, N can be 2, 4, 8, 16, 32, 64, 128, 256, 512 or 1024. |
High Resolution | 12 bit (max.) |
Interpolation | Sin(x)/x (optional) |
Minimum Detect Pulse Width | Digital channel: 10 ns |
Memory Depth | Analogue channel: 24 Mpts (single-channel), 12 Mpts (dual-channel), 6 Mpts (three/four-channel) Digital channel: 24 Mpts (8-channel), 12 Mpts (16-channel) |
Input | |
---|
Number of Channels | DS1XX4Z Plus/1XX4Z-S Plus: 4 analogue channels, 16 digital channels available after upgrade DS1054Z: 4 analogue channels |
Input Coupling | DC, AC or GND |
Input Impedance | Analogue channel: (1 MΩ±1%) || (15 pF±3 pF) Digital channel: (100 kΩ±1%) || 8 pF±3 pF) |
Probe Attenuation Coefficient | Analogue channel: 0.01X to 1000X, in 1-2-5 step |
Maximum Input Voltage (1MΩ) | Analogue channel: CAT I 300 Vrms, CAT II 100 Vrms, transient overvoltage 1000 Vpk Digital channel: CAT I 40 Vrms, transient overvoltage 800 Vpk |
Horizontal | |
---|
Timebase Scale | 5 ns/div to 50 s/div |
Maximum Record Length | 24 Mpts |
Timebase Accuracy | ≤ ± 25 ppm |
Clock Drift | ≤ ± 5 ppm/year |
Maximum Delay Range | Negative delay: 1/2 (Memory Depth/Sample Rate) Positive delay: 1 s to 500 s |
Timebase Mode | YT, XY, Roll |
Number of X-Y’s | 1 |
Waveform Capture Rate | 30,000 wfms/s (dots display) |
Zero Offset | ±0.5div*minimum time base scale |
Vertical | |
---|
Bandwidth (-3dB) | DS1104Z Plus/1104Z-S Plus: DC to 100 MHz DS1074Z Plus/1074Z-S Plus: DC to 70 MHz DS1054Z: DC to 50 MHz |
Single-shot Bandwidth | DS1104Z Plus/1104Z-S Plus: DC to 100 MHz DS1074Z Plus/1074Z-S Plus: DC to 70 MHz DS1054Z: DC to 50 MHz |
Vertical Resolution | Analogue channel: 8 bits Digital channel: 1 bit |
Vertical Scale (Probe ratio is 1X) | 1 mV/div to 10 V/div |
Offset Range (Probe ratio is 1X) | 1 mV/div to 499 mV/div: ± 2 V 500 mV/div to 10 V/div: ± 100 V |
Bandwidth Limit | 20 MHz |
Low Frequency Response (AC coupling, -3dB) | ≤5 Hz (on BNC) |
Calculated Rise Time | DS1104Z Plus/1104Z-S Plus: 3.5 ns DS1074Z Plus/1074Z-S Plus: 5 ns DS1054Z: 7 ns |
DC Gain Accuracy | <10 mV: ±4% full scale ≥10 mV: ±3% full scale |
DC Offset Accuracy | ±0.1 div ± 2 mV ± 1% offset |
Channel to Channel Isolation | DC to maximum bandwidth: >40 dB |
Trigger | |
---|
Trigger Level Range | ±5 div from the centre of the screen |
Trigger Mode | Auto, Normal, Single |
Holdoff Range | 16 ns to 10 s |
High Frequency Rejection | 75 kHz |
Low Frequency Rejection | 75 kHz |
Trigger Sensitivity | 1.0 div (below 5 mV or noise rejection is enabled) 0.3 div (above 5 mV and noise rejection is disabled) |
Edge Type | Rising, Falling, Rising/Falling |
Pulse Condition | Positive Pulse Width (greater than, lower than, within specified interval) Negative Pulse Width (greater than, lower than, within specified interval) |
Pulse Width | 8 ns to 10 s |
Pulse Width Condition | None, >, <, <> |
Polarity | Positive, Negative |
Pulse Width Range | 8 ns to 10 s |
Windows Type | Rising, Falling, Rising/Falling |
Trigger Position | Enter, Exit, Time |
Windows Time | 8 ns to 10 s |
Edge Type | Rising, Falling |
Idle Time | 16 ns to 10 s |
Edge Number | 1 to 65535 |
Slope Condition | Positive Slope (greater than, lower than, within specified interval) Negative Slope (greater than, lower than, within specified interval) |
Time Setting | 8 ns to 10 s |
Signal Standard | NTSC, PAL/SECAM, 480P, 576P |
Pattern Setting | H, L, X, Rising, Falling |
Edge Type | Rising, Falling |
Delay Type | >, <, <>, >< |
Delay Time | 8 ns to 10 s |
Edge Type | Rising, Falling, Rising/Falling |
TimeOut Value | 16 ns to 10 s |
Pattern | H, L, X |
Trigger Condition | >, <, <> |
Duration Time | 8 ns to 10 s |
Edge Type | Rising, Falling |
Data Pattern | H, L |
Setup Time | 8 ns to 1 s |
Hold Time | 8 ns to 1 s |
Polarity | Normal, Invert |
Trigger Condition | Start, Error, Check Error, Data |
Baud Rate | 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps, 57600 bps, 115200 bps, 230400 bps, 460800 bps, 921600 bps, 1 Mbps and User |
Data Bits | 5 bits, 6 bits, 7 bits, 8 bits |
Trigger Condition | Start, Restart, Stop, Missing Ack, Address, Data, A&D |
Address Bits | 7 bits, 8 bits, 10 bits |
Address Range | 0 to 127, 0 to 255, 0 to 1023 |
Byte Length | 1 to 5 |
Trigger Condition | Timeout, CS |
Timeout Value | 16 ns to 10 s |
Data Bits | 4 bit to 32 bit |
Data Line Setting | H, L, X |
Measure | |
---|
Cursor | Manual mode: Voltage deviation between cursors ( △V ) Time deviation between cursors ( △T ) Reciprocal of △T (Hz) (1/ △T ) Track mode: Voltage and time values of the waveform point Auto mode: Allow to display cursors during auto measurement |
Auto Measurement | Analogue channel: Period, Frequency, Rise Time, Fall Time, Positive Pulse Width, Negative Pulse Width, Positive Duty Cycle, Negative Duty Cycle, tVmax, tVmin, Positive Rate, Negative Rate, Delay 1→2 , Delay 1→2 , Phase 1→2 , Phase 1→2 , Maximum, Minimum, Peak-Peak Value, Top Value, Bottom Value, Amplitude, Upper Value, Middle Value, Lower Value, Average, Vrms, Overshoot, Pre-shoot, Area, Period Area, Period Vrms, Variance Digital channel: Period, Frequency, Positive Pulse Width, Negative Pulse Width, Positive Duty Cycle, Negative Duty Cycle, Delay 1→2 , Delay 1→2 , Phase 1→2 , Phase 1→2 |
Number of Measurements | Display 5 measurements at the same time |
Measurement Range | Screen or cursor |
Measurement Statistic | Average, Max, Min, Standard Deviation, Number of Measurements |
Counter | Hardware 6 bits counter (channels are selectable) |
Display | |
---|
Display Type | 7.0 inch TFT LCD display |
Display Resolution | 800 horizontal × RGB × 480 vertical pixel |
Display Colour | 16 million color (24 bit true color) |
Persistence Time | Min, 100 ms, 200 ms, 500 ms, 1 s, 5 s, 10 s, Infinite |
Display Type | Dots, Vectors |
I/O | |
---|
Standard Ports | USB Host, USB Device, LAN, AUX Output (TrigOut/PassFail) |
General Specifications | |
---|
Output Voltage | About 3 V, peak-peak |
Frequency | 1 kHz |
Power Voltage | 100 V to 240 V, 45 Hz to 440 Hz |
Power | Maximum 50 W |
Fuse | 2 A, T degree, 250 V |
Temperature Range | Operating: 0℃ to +50℃ Non-operating: -40℃ to +70℃ |
Cooling Method | Fan cooling |
Humidity Range | 0℃ to +30℃ : ≤95℃ relative humidity, +30℃ to +40℃ : ≤75℃ relative humidity, +40℃ to +50℃ : ≤45℃ relative humidity |
Altitude | Operating: under 3,000 meters, Non-operating: under 15,000 meters |
Dimensions | Width × Height × Depth = 313.1 mm × 160.8 mm × 122.4 mm |
Weight | Without package 3.2 kg ± 0.2 kg, With package 3.8 kg ± 0.5 kg |
Calibration Interval | The recommended calibration interval is 18 months. |
Reviews
There are no reviews yet.